I'll put in my 2 cents & personal experience here... Similar to the previous mention of problematic circuit boards. My DTXpress I set was having problems with my kick missing some trigger hits...I ordered TWO new replacement triggers & I replaced the trigger. Well guess what? Did not help at all! Damn! Then I took it appart again & checked the circuit board & trigger jack connection. Seemed ok - Even under a magnifying glass! Well, I re-soldered the connections anyway just in case there was a hair line broken solder joint...BINGO!!! For the 1st time in almost a year it's dead on! Steve DTXpress@yahoogroups.com, "adamh52683" <adamh526@h...> wrote: > I've had my dtxpress 2 for a couple of months now and have noticed > that the pad on my kp65 has a small indent at the top of its impact > point. My question is, does this effect the triggers response to a > noticable degree and what problems should I look for before deciding > that I need to replace the entire kp65 unit? Thanks. > > Adam
Message
Re: Is my KP65 dying?
2003-11-12 by zapaxe