Yamaha DTXpress/DTXplorer/DTXtreme

I have a DTXpress 2 and followed the steps written in the manual about 
changing the low, mid, and high click voices and found that I am unable to 
make the click just one voice. The best I could do is two voices. Does anybody 
know the answer?

I discovered a great product for drummers who have grown tired of the 
programmed DTXpress songs. It is a CD called "Turn it up, Lay it down" and 
has 25 hot bass tracks to play along with covering a variety of styles. Check it 
out at rhythmtech.com  I got mine at Guitar Center for $13.

David

Hi All,

The post below was written in 2002, unfortunately nobody replied so I 
thought I'd repost and see if anyone could help. I'm getting the 
nearly the same problem (although I'm using a DTX 3).

I want to make the click all one voice and volume. When I go into the 
Utility mode/Click Group I can change the clk voiceset (metronome 
etc) but when I page down to UT CLK VOICE I can't make any chnages.

I've followed (I think) the instructions on page 34 section 4.2 of 
the reference manual but can't seem to make any changes. Does anyone 
else have this problem?

Thanks
Paul


--- In DTXpress@yahoogroups.com, "David" <fantic250@...> wrote:
>
> I have a DTXpress 2 and followed the steps written in the manual 
about 
> changing the low, mid, and high click voices and found that I am 
unable to 
> make the click just one voice. The best I could do is two voices. 
Does anybody 

> know the answer?
> 
> David
>

--- In DTXpress@yahoogroups.com, "Paul" <northstandpaul@...> wrote:
>
> Hi All,
> 
> The post below was written in 2002, unfortunately nobody replied so I 
> thought I'd repost and see if anyone could help. I'm getting the 
> nearly the same problem (although I'm using a DTX 3).
> 
> I want to make the click all one voice and volume. When I go into the 
> Utility mode/Click Group I can change the clk voiceset (metronome 
> etc) but when I page down to UT CLK VOICE I can't make any chnages.
> 
> I've followed (I think) the instructions on page 34 section 4.2 of 
> the reference manual but can't seem to make any changes. Does anyone 
> else have this problem?

Paul,

I am sure you can do what you want - I have done it from time to time.

You need to change the UT CLK VOICESET to "User Voice" (section 4.1).
 Then select the same voice (I use the woodblock sound), tuning and
volume for each of the three clicks.

Keith.

Thanks Keith, works fine.

> Paul,
> 
> I am sure you can do what you want - I have done it from time to time.
> 
> You need to change the UT CLK VOICESET to "User Voice" (section 4.1).
>  Then select the same voice (I use the woodblock sound), tuning and
> volume for each of the three clicks.
> 
> Keith.
>