Digital BW, The Print

Thanks, I will try that as well. Not a foolish question about the right placement - a few years back the answer to "did you plug it in?" was actually "no".

--- In DigitalBlackandWhiteThePrint@yahoogroups.com, Phillip Kimble <grimmieoldfart@...> wrote:
>
> Make sure you removed the air plugs from the cartridges. If you look on top of 
> the cartridge there should be 2 plugs, a clear one on the back and a colored one 
> towards the top (the top being closer to the inside of the printer). Remove the 
> clear plugs as these allow air into the cartridge. The colored plugs are used 
> for refilling and should stay in at all times except when refilling.
> 
> After that, run a few cleaning cycles until you start to see ink. You could also 
> run a few test prints instead. The problem with new cartridges is they are not 
> primed. Therefore you have to priome them to get the ink flowing. 
> 
> 
> Stupid question but possible, you do have ink in the cartiridges, right?
> 
> 
> 
> 
> ________________________________
> From: hovikgbg <hovikgbg@...>
> To: DigitalBlackandWhiteThePrint@yahoogroups.com
> Sent: Sat, March 5, 2011 6:50:52 AM
> Subject: [Digital BW] mis ut7 on epson 2200
> 
> Â  
> I installed UT7 on my Epson 2200. It is supposed to work with the Epson driver 
> using Paul Roark workflow. The 2200 simply will not print - even maintanence, 
> nozzle check. I cannot find profiles on his web page. Must I use QTR or 
> alternative? If I install QTR driver, how do I get Epson driver back when I wish 
> to use full color Epson. I use Win XP SP 3, LR3, PS CS3. By the way, I 
> reinstalled the Epson cartridges and I print just fine - except for the 
> metamerism and a color cast (usually green sometimes magenta) in my B&W which 
> got me to order the UT7 in the first place. What to do?
> 
> 
> 
> 
> 
>       
> 
> [Non-text portions of this message have been removed]
>