Yahoo Groups archive

Digital BW, The Print

Index last updated: 2026-04-28 22:56 UTC

Message

Re: Cutting Down Roll Paper?

2015-09-01 by benjschneider2@...

I use the 12 inch miter saw, and the metal cutting blade which I use to cut frame sections. I first wrap a piece of masking tape around where the cut is to be made, mark it, set the saw to 90 degrees and cut. I get an edge as clean or cleaner then the factory cuts.

I didn't think the 3880 could use roll paper. Tell me about it. I was considering one but gave up on the idea because of the roll paper issue.

Ben

Attachments

  • No local attachments were found for this message.

Move to quarantaine

This moves the raw source file on disk only. The archive index is not changed automatically, so you still need to run a manual refresh afterward.