Digital BW, The Print

>>This happens to me occasionally, daily I make sure to reseat the velcro'd
plastic bar  that sits on top of printer and holds the tubing. Heat seems to
be a factor. I think I will insert something under the plastic tubing holder
to keep it from sagging.<<

Today, I had to reposition the "arm" on my 1160.  During initial
installation, I knew I would probably be sorry if I "followed the picture
directions" and attached the arm over the factory instructions (paper
sticker).  The instruction sticker finally pulled away today :(  I cut the
sticker so that I now have a good adhesion surface, cleaned all the old
adhesive off the arm and used the "heavy duty" version of the "Scotch
Mounting" pads/squares (found at my local hardware store) to remount the
arm. I have had great luck with this stuff in other applications where
Velcro has not had enough adhesive.  You might want to give this stuff a
try.

Doug