Digital BW, The Print

Richard, thanks for the reply...

I'm not using "unsupported ink" setting. I used Hahnemuehle Photo Rag 188gsm
to experiment the plug-in\ufffd
Other settings are as follows: Profile = Hahnemuehle Photo Rag 188, Dot Gain
= 100%, Gamma = 1.00.

The results are only better at highlights (no visible dots), but I get
microbanding elswhere. And as I said before; way too flat. I'm printing from
Photoshop 6.0, Mode = Grayscale, Profile = Gamma 2.2. Is there anything
wrong in these settings?

Regards,
Loris.

----- Original Message -----
From: "Richard Sintchak" <richard@...>
To: "Loris Medici" <DigitalBlackandWhiteThePrint@yahoogroups.com>
Sent: Monday, September 30, 2002 8:34 AM
Subject: Re[2]: [Digital BW] Cone Announces New Blacks


> Loris,
>
> Do not use the Unsupported Ink setting in PiezoBW driver even though
> you are.  I use the ConeTech Ink setting for my 1160 and FS-N inks and
> the results are MUCH better.