Digital BW, The Print

I still think that the best solution is a redesign that spans the open area of the printer, I just 
haven't made one yet. I did install per instructions, but there's a lot of leverage and tug on that 
adhesive.

Tim

> The information below is from tech support at nomorecarts.com, who
> asked that it be posted in this forum.
> 
> >>The velcro included with the CIS kits need to be attached securely
> >>when
> you
> first get it.  If it pulls off, it will never stick properly again -
> it only reaches maximum strength the first time it is use.  Please
> contact us for a free replacement piece of velcro, along with an
> alcohol prep pad to clean the printer first to insure a good bond the
> first time.  Don't forget to push the velcro down firmly when you
> install it.<<
> 

--
Tim Spragens
http://www.borderless-photos.com