Digital BW, The Print

When I first installed the CIS I had problems with the arm sagging, so I
took the rubber stopper that they give you to prop the lid open with, and I
mounted it on the inside of the lid in such a way that when the lid closes
the stopper rests on the base of the arm and holds it in place. Just make
sure it rests only on the arm and not on the tubing. The weight of the lid
is enough to keep the adhesive from peeling up.

-Jason

-----Original Message-----
From: Tim Spragens [mailto:t.spragens@...]
Sent: Monday, September 24, 2001 2:03 PM
To: digitalBlackandWhiteThePrint@yahoogroups.com
Subject: Re: [Digital BW] CIS and velcro arm attachment


I still think that the best solution is a redesign that spans the open area
of the printer, I just
haven't made one yet. I did install per instructions, but there's a lot of
leverage and tug on that
adhesive.

Tim

> The information below is from tech support at nomorecarts.com, who
> asked that it be posted in this forum.
>
> >>The velcro included with the CIS kits need to be attached securely
> >>when
> you
> first get it.  If it pulls off, it will never stick properly again -
> it only reaches maximum strength the first time it is use.  Please
> contact us for a free replacement piece of velcro, along with an
> alcohol prep pad to clean the printer first to insure a good bond the
> first time.  Don't forget to push the velcro down firmly when you
> install it.<<
>