Digital BW, The Print

A few points on installing and using the 2200 Eboni cartridge:
1.There is a piece of yellow tape on top that covers a small vent hole 
in the cartridge - you should remove this tape before installing the 
cartridge.
2. Do not shake the cartridge prior to installation as recommended for 
the Epson carts.  The lower viscosity of the Eboni might produce 
excessive foaming and air blocks if it is shaken up.
3. Use all of the Eboni before switching back to Epson matte K or Photo 
K.  The MIS carts do not have self sealing poppet valves, so if you do 
remove a partially used Eboni cart you will have to seal the bottom 
hole or there will be a lot of leakage.


On Tuesday, March 2, 2004, at 12:11  PM, julie stapen wrote:

> I want to make sure i get it right before going out
> and buying the ebony ink for my 2200. From what i've
> seen, you get the best and most neutral black and
> white print from the 2200 when using the eboni black
> ink and BO printing... does the print still need to be
> sprayed if it's on matte paper? the velvet fine art or
> enhanced matte? and what do you spray it with? also,
> is there anything i should know about the eboni ink
> and how to install it/clean in my 2200? Do i have to
> download something, or does it work the same as the
> matte black?
> Thanks so much! I am really looking foward to getting
> started on this today and an advice would be greatly
> appreciated.
> Julie
>