Digital BW, The Print

I should follow up on my plight.......I never got a good nozzle 
check, and the stripes at either end never went away.  MIS promptly 
sent me out an entire new set.  I replaced only the Eboni cartridge 
(the one I thought was the problem, especially after looking at the 
nozze checks, and it is has been smooth sailing ever since.  I'm 
going to pay MIS for the second set, minus the replacement Eboni.  
That is good service.

--- In DigitalBlackandWhiteThePrint@yahoogroups.com, "jim_g_bradley" 
<jgbjunk@s...> wrote:

> I recieved my inks last night and had exactly the same issues.  I 
ran 
> several nozzel check/ clean cycles and tried several different 
> setting, curves vs sliders, different profiles for curves ,etc.  
> Until the nozzel check showed perfect patterns I got very obvious 
> lines near the edge of the print and faint lines through out using 
> EAM.  After I finally ran a clean/check sequence on a peice of 
scrap 
> EAM instead of photo copy paper everything was good.  This might 
have 
> just been that final necessary clean/check cycle or I should have 
> used EAM all along, I don't know.  
> Since the clean/check cycle worked I have gotten very good initial 
> results on EAM and Professional Luster.