Digital BW, The Print

Keith, have you tried swapping carts to either Epson OEM or the MIS $5
dye carts? That will isolate your problem to output/driver/printer or
carts/ink. If carts/ink just ask MIS to swap them out. If
output/driver/printer then try a standard, no adjustment needed, file
to narrow it down to output/driver/printer. 

Just follow a simplistic diagnostic process to isolate the problem. I
bet the solution will be obvious once you know the true problem. 

Also look on the tech support section of the MIS website. The answer
to almost every question is there. It's just time consuming to find it. 

Bob Michaels

  --- In DigitalBlackandWhiteThePrint@yahoogroups.com, Keith Hollister
<khollist@b...> wrote:
> I have recently developed a couple of problems with my 1280 loaded with 
> MIS UT carts. The first issue is a very noticeable green cast. I have 
> triple checked my workflow as well as nozzle checks to no avail. I 
> decied to try a black-only to see if the Eboni ink looked right - the 
> color was OK (warm but free of other colors), but I have microbands 
> except in the first 1/2 inch of the print. After the first 1/2 inch is 
> printed the banding starts. This is not visible in a color (greys) 
> print. I have tried alignment and cleaning, but no luck.
> 
> Ideas?
> 
> Keith Hollister