Digital BW, The Print

Just take a hacksaw to your existing bracket until it fits. It sounds
like you may have gotten a 1280 bracket. All you need is a small piece
to hold the tubes up out of the way. 

You can ask MIS but it's easier to cut yours down to fit rather than
sending it back for a replacement. look at the photos on the MIS
website. If your's doesn't look like the one for the 890 shown there,
just cut it down till it does. 

Bob Michaels

--- In DigitalBlackandWhiteThePrint@yahoogroups.com, "Richard Vanek"
<richard.vanek@e...> wrote:
> Dear friends,
> 
> anybody installed MIS CFS for 890 or 870 printer?
> 
> I am just about to install CFS for my epson photo 890. I unwrap tube 
> bracket and wanted to glue it 4 3/8" (11.1cm) from right side, when I 
> realize I can't take cartridges out than because left side of tube 
> bracket is going far much too left and leaving not enough space for 
> removing cartridges. It goes (on left side) about 1.3" (3cm) further 
> than extra space is made in plastic of printer for removing of the 
> cartridges.
> 
> I am afraid that I have received tube bracket for epson 1280. Is that 
> possible has CFS for 1280 different size (length) of tube bracket 
> than 890? 
> 
> I would expect that tube bracket should finished on left side at the 
> place where opening in plastic is little bigger for cartridges. 
> 
> The length of tube bracket I have is 5" (12.7cm) In case is too long 
> can I just cut it? 
> 
> 
> Thank you for your help.
> 
> --
> richard vanek
> http://piskoftak.com/