Digital BW, The Print

MIS has changed the bracket since they made my 1280 CFS. Mine is only
about 1" wide (now long) and worked on either a 1280 or 890 by
locating it differently. It appears your new bracket allows you to
close the lid. I just took my lid off and put it in the closet several
years ago. 

It appears you've found the photo of the 890 bracket on the MIS site
at http://www.inksupply.com/index.cfm?source=html/cfs_890_new.html 
Also one of the 1280 bracket at
http://www.inksupply.com/index.cfm?source=html/cfs_1280_new.html

I bet they sent you the 1280 bracket but you could easily make it into
the 890 one with a hacksaw. The length certainly is not critical
unless it's too long as it appears yours is. 

Bob Michaels

--- In DigitalBlackandWhiteThePrint@yahoogroups.com, "Richard Vanek"
<yahoo@p...> wrote:
> Bob,
> 
> thanks for the answer. 
> 
> > Just take a hacksaw to your existing bracket until it fits. It 
> sounds
> > like you may have gotten a 1280 bracket. All you need is a small 
> piece
> > to hold the tubes up out of the way. 
> 
> 
> I was thinking about to cut it because based on picture from MIS web 
> site both tube bracket for 890 and 1280 ends on left side exactly at 
> place where extending area is made in plastic printer part to allow 
> remove of the cartridges.
> 
> I just wanted to be sure so I asked here people with CFS on 890 and 
> 1280 if it is really true and what length of the tube bracket they 
> have.
> 
> > You can ask MIS but it's easier to cut yours down to fit rather than
> > sending it back for a replacement. look at the photos on the MIS
> 
> Sure. I wrote to MIS on their forum as well as submit support ticket. 
> Not real answer so far, so I didn't finished CFS installation 
> yesterday.
> 
> I still do not know if there are two different length of tube bracket 
> for 890 and 1280. So  please if you have CFS for epson 1280 or epson 
> 890 could you send me length of your tube bracket?
> 
> Thank you!
> 
> ---
> richard vanek
> http://piskoftak.com/