Digital BW, The Print

I feed PR308 through the top feed of my `1280 with no problem. I need
to leave the selector set to -0- or it doesn't print as cleanly.
Everything is exactly as I print EEM. This may not be the "proper" way
but it works good for me.

Bob Michaels

 --- In DigitalBlackandWhiteThePrint@yahoogroups.com, "Ken Carney"
<kcarney1@c...> wrote:
> Hmm...I've been using PR308 in the sheet feeder (2200) with the
selector set
> to +.  Everything _seems_ to work as normal, but is that a problem
perhaps?
> 
> Regards,
> 
>   --Ken Carney
>     www.kencarney.com  
> 
> > -----Original Message-----
> > From: Josh Freeman [mailto:quakewarning@y...] 
> > Sent: Sunday, September 05, 2004 11:53 AM
> > To: DigitalBlackandWhiteThePrint@yahoogroups.com
> > Subject: [Digital BW] Re: Can I feed 380 gsm paper through 
> > the top slot in the 2100?
> > 
> > Through the back. The 2200 I have recommends the manual feed 
> > slot for velvet fine art which is a lowly 260gsm. So a 
> > heavier 380 is way more.
> > It's not that hard, after moving the lever, push the paper in 
> > until ysee a half inch or so and hold it against the right 
> > edge of the slot. There is enough of an edge in there that 
> > you can rock the paper and you can feel it when it is square. 
> > Then while holding the paper raise the lever 2 notches and 
> > you're ready.