Digital BW, The Print

I ran a few cleaning cycles and then hosed my printer down with canned
air, and also cleaned the parking pads a little. This didn't work but
good advise anyway (man was it dirty in there!).

Next i unchecked high speed, and problem solved.  Her name is now
Gramma, but hey she gets the job done;)

Thanks Jerry
John

--- In DigitalBlackandWhiteThePrint@yahoogroups.com, Jerry in Houston
<glewis4457@y...> wrote:
> I have a 1280 using the MIS UT2 CFS system, mostly
> using EEM and Pauls curves.  I was also getting those
> pesky lines. Ran lots of nozzle cheaning cycles with
> no significant improvement.  Then, I happened to check
> my printer settings and saw that I still had "High
> Speed" checked. When I changed the settings to turn
> off high speed the lines went away.  Go figgur.  Try
> it and see what happens.  Slows down the printing
> process but saves a bunch on paper and angst.
> 
> Jerry in Houston
> 
>  --- In DigitalBlackandWhiteThePrint@yahoogroups.com,
> "weareallsosmall" <weareallsosmall@y...> wrote:
> > hi everybody
> > 
> > I'm getting lines on most of my prints that extend 
> about a half inch
> > outside the print area.  These lines are all 
> travelling in the
> > direction of the print head, and are caused by what 
> looks like the
> > magenta head. In most cases it's just a few lines, 
> somtimes its many
> > MANY lines, and every so often I get lucky and get a
> 
> line free print.
> > Any ideas as to what's causing this and how I can 
> fix it?
> > 
> > Thanks 
> > john