Digital BW, The Print

In a message dated 10/24/2004 4:48:49 PM Pacific Daylight Time, 
deanwork2003@... writes:

> -Make sure those ink lines on the far right side, that go down into the 
> overflow pads are in 
> the correct position and not blocking the home position of the head. You 
> could have 
> knocked them out of the socket they sit in. This happened to me when I 
> reached back in 
> there and cleaned around the heads.
> 
I did finally find some mal aligment and got the gears to engage, Yes you can 
power it up without the right side cover on. Anyway the service error 
0001000c Went away.
Now I have two dampers that will not fill, even after an init fill and kk2's.
I left the cover off the head and damper assembley so I can see whats going 
on. No ink in two of the dampers.
Steve M.


[Non-text portions of this message have been removed]