Digital BW, The Print

tonight i installed QTRgui version 2.1d. work very well and easy. 
 in PS CS, using a bitches brew of UT (FSN), EZN, and Epson 
UltraChrome lite Cyan (MIS equivalent) in my yellow chamber, i have 
been able to achieve the best results i have in the two years i've 
been doing this.
  the PS curves where quite slow in getting me there. QTRgui got me 
to "almost" the same place (little less smooth in the highlights / 
little less control over specific densities .... 60-70-80%), in about 
15 minuets. i spent DAYS on those PS curves!

i didn't seem to have the problems with installation / printing that 
a lot here have.
 
the only problem i continue to run into is this ..... when printing 
anything with the resolution set to 1440 super or below, it come out 
fine. when i select 2880 dpi. it ALWAYS stretches the image height 
(not width) to approximately double the height as the actual file.

anyone had a similar problem? any thoughts as how to correct it?

evanj