Digital BW, The Print

I'm not sure which printer you are using.   The desktops i.e. 2200
don't support 2880 correctly yet.  The pro printers 4000, x600 will
run at 2880 but the builtin profiles are made for 1440.

The stretching of one dimension sounds like it might be a 16bit file
issue rather than a resolution issue but I can't tell for sure.

Roy


--- In DigitalBlackandWhiteThePrint@yahoogroups.com, "evanj1969" <evanj69@b...> 
wrote:
> 
> tonight i installed QTRgui version 2.1d. work very well and easy. 
>  in PS CS, using a bitches brew of UT (FSN), EZN, and Epson 
> UltraChrome lite Cyan (MIS equivalent) in my yellow chamber, i have 
> been able to achieve the best results i have in the two years i've 
> been doing this.
>   the PS curves where quite slow in getting me there. QTRgui got me 
> to "almost" the same place (little less smooth in the highlights / 
> little less control over specific densities .... 60-70-80%), in about 
> 15 minuets. i spent DAYS on those PS curves!
> 
> i didn't seem to have the problems with installation / printing that 
> a lot here have.
>  
> the only problem i continue to run into is this ..... when printing 
> anything with the resolution set to 1440 super or below, it come out 
> fine. when i select 2880 dpi. it ALWAYS stretches the image height 
> (not width) to approximately double the height as the actual file.
> 
> anyone had a similar problem? any thoughts as how to correct it?
> 
> evanj