Digital BW, The Print

Have you tried the Yahoo ImagePrint forum?  They would probably be 
the most likely group to help answer your question.  

http://groups.yahoo.com/group/ImagePrint/

Lou

--- In DigitalBlackandWhiteThePrint@yahoogroups.com, "fchriscarter" 
<chris.carter@s...> wrote:
> 
> I have recently up graded to IP v6 after using 5.6 without problems.
> I can install IP OK and get the programme "Enabled"
> When I turn my system on again after shutting down at night IP 
> cannot fing the dongle.
> The IP Support staff are being very helpful but so far the problem 
> is not solved.  After un-installing the dongle MARKS files and 
> reinstalling then re-inserting the Dongle the windows USP programme 
> runs but fails to make the necessary connection(Error Message)  
Then 
> when I start IP the dongle number is OK and I can print.  After re-
> boot same problem , no dongle connection.  Looking in Windows 
Device 
> Manager there is an ! mark after installation against the USB v2 
> line.  After the re-boot the exclamation mark changes to an red X 
> over the USB symbol.  I did install Windows Service pack 2 when it 
> came out some months ago.
> Anyone had this problem or ideas on a solution ?
> Chris