Digital BW, The Print

Thanks, will try that forum
Chris
--- In DigitalBlackandWhiteThePrint@yahoogroups.com, "ldina" 
<lbdina@c...> wrote:
> 
> Have you tried the Yahoo ImagePrint forum?  They would probably be 
> the most likely group to help answer your question.  
> 
> http://groups.yahoo.com/group/ImagePrint/
> 
> Lou
> 
> --- In 
DigitalBlackandWhiteThePrint@yahoogroups.com, "fchriscarter" 
> <chris.carter@s...> wrote:
> > 
> > I have recently up graded to IP v6 after using 5.6 without 
problems.
> > I can install IP OK and get the programme "Enabled"
> > When I turn my system on again after shutting down at night IP 
> > cannot fing the dongle.
> > The IP Support staff are being very helpful but so far the 
problem 
> > is not solved.  After un-installing the dongle MARKS files and 
> > reinstalling then re-inserting the Dongle the windows USP 
programme 
> > runs but fails to make the necessary connection(Error Message)  
> Then 
> > when I start IP the dongle number is OK and I can print.  After 
re-
> > boot same problem , no dongle connection.  Looking in Windows 
> Device 
> > Manager there is an ! mark after installation against the USB v2 
> > line.  After the re-boot the exclamation mark changes to an red 
X 
> > over the USB symbol.  I did install Windows Service pack 2 when 
it 
> > came out some months ago.
> > Anyone had this problem or ideas on a solution ?
> > Chris