Digital BW, The Print

I had the exact same problem although I did use the translucent plugs, I did 
withdraw a small amount of ink from each chamber and I did get a good nozzle 
check.  However, with my first print, large ink  drops appeared on the left 
portion of the print and smeared nearly halfway across.  After hours of 
fooling around with it I did a head-cleaning per Paul's instructions.  The 
same thing happened again.  I then installed a refilled UT1 cart and am 
getting good nozzle checks and prints with no banding or ink drops.  Have 
not yet re-installed the spongeless clear cart with UT2 inks after letting 
it sit for two days.  BTW, I did leave in the spongeless cart with Eboni so 
that particular cart was not the problem.  Will advise when I re-install the 
5 chamber clear cart.  Maybe a defective cart?

Barbara
----- Original Message ----- 
From: "toniko74" <t.zakrzewski@...>
To: <DigitalBlackandWhiteThePrint@yahoogroups.com>
Sent: Saturday, April 09, 2005 4:42 PM
Subject: [Digital BW] First try of MIS clear cartridges - a disaster