Digital BW, The Print

>I think you may have damaged the needles when putting them on
>over the cap. If you have any good ones left they can be
>reused by rinsing them in water. You may be able to tape over
>the fill holes untill you get plugs from MIS. That should
>prevent ink splashing while the printer is running.

I'd agree with you if I had attempted to fit *all* of the needles 
(incorrectly) over the syringe cap. I did this with one, maybe two 
of the needles -- but definitely not with all four of them that are 
broken.

On the filler cap issue, I was told my MIS in an e-mail from support 
that THERE ARE NO CAPS for these 2200 cartridges, that caps are only 
necessary when used with CFS systems...

Funny but I have two pre-filled cartridges (identical to my new, 
empty ones) that DO have caps.

All responses here on the forum talk about caps, yet a 
representative of the vendor say caps aren't used...

Is this another case in my short dealings with MIS where one hand 
doesn't know about the other?

Comments?