Digital BW, The Print

Over on the DPReview.com forum, there has been some discussion of the 
MIS Clear Cartridges and those little rubber plugs...some folks have 
reported ink leaks at the print head and suspect the rubber plugs are 
not sealing correctly, letting air in as the ink flows out t he 
bottom. I'm thinking a litte bit of black electrical tape over these 
holes (with ot without the rubber plugs in place) should do a very 
acceptable job of making an air tight seal...and will be easy to lift 
off for refilling later.

Mike.

--- In DigitalBlackandWhiteThePrint@yahoogroups.com, "kenstrain2000" 
<kenstrain2000@y...> wrote:
>
> > As I posted a little while ago, an e-mail from MIS support said 
that 
> > plugs are not used on these clear 2200 cartridges... 
> > 
> > >(On the other hand I had problems too, with leaks.)
> > 
> > Oh crap, I don't need to here about that...! :)
> Well if the hole is meant to be open there can't be a problem due to
> any small leaks:)  I am not sure which cartridges you have.  Your
> first post mentioned the online support for them as saying there were
> plugs.  
> Ken
>