Digital BW, The Print

Hi again.... I've printed a couple of 100 step charts, one for the warm and one for the cool 
QTR curves.  The warm stepwedge looks normal to me but the cool (which uses K, M and 
LM) has a peculiar violet cast to it.  I'm going to write an email to MIS support.

Ed


--- In DigitalBlackandWhiteThePrint@yahoogroups.com, "edrudolpho" <erudolph@p...> 
wrote:
>
> I'll send you a QTR calibration chart...
> Ed
> 
> 
> --- In DigitalBlackandWhiteThePrint@yahoogroups.com, "Paul Roark" <paul.roark@v...> 
> wrote:
> >
> > Ed,
> > 
> > A reddish hue has nothing to do with the new base.  It's more clear and
> > colorless than the old base.  Hopefully there isn't a bad mix out there.  If
> > you'd like to send me some samples, I'll check them with the
> > spectrophotometer.
> > 
> > Paul
> > www.PaulRoark.com 
> > 
> > 
> > > -----Original Message-----
> > > From: DigitalBlackandWhiteThePrint@yahoogroups.com
> > > [mailto:DigitalBlackandWhiteThePrint@yahoogroups.com] On Behalf Of
> > > edrudolpho
> > > Sent: Friday, October 28, 2005 8:47 AM
> > > To: DigitalBlackandWhiteThePrint@yahoogroups.com
> > > Subject: [Digital BW] UT7 color change: Paul?
> > > 
> > > This question is perhaps best answered by Paul, but all info is welcome.
> > > 
> > > I'm using UT7 with QTR on a 2200 and have been using up a supply of ink
> > > I've had for a
> > > while.  I just changed a number of carts (LC, LM and M) and replaced them
> > > with a shipment
> > > I received a few weeks ago.  Here's the problem:  I'm not noticing a
> > > distinct reddish tone in
> > > the prints, something I've not seen before.  Is this something to do with
> > > the new base, and
> > > is it recommended to reprofile for the new base?
> > > 
> > > Ed