Digital BW, The Print

Hi Gary,

I've been wondering what could be causing your situation.   I just (again)
tried my R2400, Windows XP, QTR 2.4.3 and positioning worked exactly correct.
I know I've mentioned using Manual Roll (Rear) and you've confirmed that.  But,
this must be done on the QTRgui page -- not on the Epson driver Page Setup.
If you select the Manual Roll on the Epson driver that has no effect on the QTR
driver since they are completely independent.  Going into "Printer & Faxes"
and setting Printer Properties is all dealing with the Epson driver.

BTW, when you say "starts printing on the far left edge" I'm assuming you are printing
landscape and the print is starting on the leading edge coming out of the
printer.  Correct?

Roy

--- In DigitalBlackandWhiteThePrint@yahoogroups.com, "Gary Benson" 
<bensonga@...> wrote:
>
> Tom, 
> 
> I have had no problems getting my 2400 to feed the paper (Epson Velvet
> Fine Art) through the single sheet rear feeder.  For both QTR and when
> printing directly from Photoshop, the paper is position the same until
> the printer actually receives the image and starts printing.  At that
> point, printing from Photoshop, the printer repositions the paper so
> that the image is correctly centered on the paper and it starts
> printing.  With QTR, the paper is not repositioned correctly and it
> just starts printing on the far left edge of the paper.
> 
> I haven't used the front sheet feeder because I don't have much room
> at the back of my printer to receive the paper.  This is one thing I
> really like about the 2400 vs the 2200 (needing less space at the back
> to feed the heavier paper through to the front tray).
> 
> I'm at a loss as to how I can fix this problem with the 2400 and QTR
> on my system.  I have only heard from 3 people who are using QTR with
> the 2400.  One of them experienced this problem, the other two did not.
> 
> When problems like this arise in digital print making the I find the
> mysteries of how a computer, printer and software all work together
> (or not) a little frustrating.
> 
> Gary Benson
> Eagle River, Alaska
> 
> 
> --- In DigitalBlackandWhiteThePrint@yahoogroups.com, "Tom Husband"
> <tom.husband@> wrote:
> >
> > I use the single sheet guide and rear feeder with QTR and have had a few
> > problems with the printer not being able to grab the paper.  It was
> remedied
> > when I took the curl out of the paper.  I haven't seen your problem
> however.
> > 
> > What paper are you using?  You can also load thick media from the front.
> > Have you tried that?
> > 
> > Tom
> >
>