Digital BW, The Print

I have been using the Top Single sheet feeder for this paper with no
Problems..I have been printing mostly 11x17 but have produced a number of
13x19s

 

Paul

 

From: DigitalBlackandWhiteThePrint@yahoogroups.com
[mailto:DigitalBlackandWhiteThePrint@yahoogroups.com] On Behalf Of Derrick
Sent: Tuesday, February 26, 2008 11:35 PM
To: DigitalBlackandWhiteThePrint@yahoogroups.com
Subject: [Digital BW] Harmon Gloss FB AL & Epson 3800 front loading problem

 

Hi,

i'm trying to get some A3+ (19x13) prints done urgently on Harmon Gloss FB
AL paper using 
my Epson 3800 via the front manual feeder. I've tried using the rear manual
feeder 
previously which works fine but i'm getting pizza tracks on the darker
prints so i switched to 
the front manual feeder. The problem now is that the print gets chopped off
slightly more 
than a 1/4 of an inch at the top and at the bottom.

My image size is 18x12 inches. Under the paper setup, i have a custom paper
size set up to 
19x13 but with 1/2 inch borders all around. This works fine using the rear
feeder but using 
the front feeder, the sides are ok (1/2 inch border on the left and right)
but the top and 
bottom have a border of slightly more than 3/4 inch (i.e. cutting off my
image at the top and 
bottom).

Appreciate any help as i've wasted quite a bit of paper trying to figure out
what is wrong. 
Thanks!

Derrick 

 



[Non-text portions of this message have been removed]