Digital BW, The Print

Hi all,

Apologies for asking a newbie question but one has to start somewhere...

I'm sure a lot of the information I am looking for is here already
somewhere but it would be great if someone could point the way :-)

Anyhow, here goes. I am shooting mostly film and spend a lot of time
with Ilford and Kodak Tri-X films. From my negatives I am scanning
them myself with a Nikon Coolscan 5000 and then printing from
Photoshop onto an Epson 3800 using the Advanced B&W mode available
from Epson. My monitor is calibrated (using a Gretag Eye-One) but I
have not done any profiling on the printer (pretty expensive from what
I understand).

So far I am reasonably happy with the prints I am getting but they're
not quite as good as I know I can get out of this equipment... I've
seen other examples in Print shops and from friends using the same
printers and they seem to have a little more of that B&W 'X-factor'
that I'm looking for. My prints always seem to have a slight cast
(green-gray). Not extreme but not perfect...

Anyhows, I'm looking for advice on a workflow or areas I need to look
at in order to get 'Exhibition quality' prints from my equipment...

Any advice is appreciated.

Rgds
Rick