Digital BW, The Print

Paul, Thanks for your reply.� I would plan to use two sets of carts -- just wondered how anal I need to be should there be a small amount of cross-mixing as in refilling a nearly empty EB6 MIS cart with Piezo K6?

Do you have any idea about� relative comparisons (warmth, etc) between these two approaches?� Both seem "on paper"� to be designed toward similar ends although yours can be used without a RIP whereas Piezo not so much -- although this is essentially a moot point for me since I have, use, and have already paid for QTR.

Thanks again... Michael

--- On Sat, 8/16/08, pr_roark <pr_roark@...> wrote:
From: pr_roark <pr_roark@...>
Subject: [Digital BW] Re: Ebony 6 and Piezography K6 for Epson 1400
To: DigitalBlackandWhiteThePrint@yahoogroups.com
Date: Saturday, August 16, 2008, 7:44 PM










    
            Michael Vendrell <mjvendrell2@ ...> wrote:



> Paul and Jon, et al:

> 

> I am interested in a comparison of these two ink systems ...

> 

> ...  wanting to switch between the systems ...



> Would there be any problem in using re-fillable MIS carts 

> for the Piezo K6 and if small amounts of either ink were 

> left in the carts is there any incompatibility issues between 

> these 2 ink sets?

...



I have no idea if Eboni-6 and K6 are compatible.



I'd recommend a separate set of carts for each.



On the other hand, if you do use the same set of spongeless carts for 

both, I'd rinse with a solution of water (65%) and glycerol (35%) 

between the 2.  Water and glycerol are in nearly all injet inks.  So, 

that mix has the best shot at being compatible with both inksets. 



Paul

www.PaulRoark. com  




      

    
    
	
	 
	
	








	


	
	


      

[Non-text portions of this message have been removed]