Digital BW, The Print

Mike, I had the same problem with the tubing catching under the printhead on
my 1280. I had the acrylic arm as far to the right as possible and it wasn't
sagging and I still had the problem. I finally solved it by taped a 1\ufffd"
piece of 5/8" wooden dowel horizontally to the left side of the black cart.
The dowel extended above
the top left corner of the cart just a little and held the tubing up just
enough to prevent any further problems. I used a single piece of good
quality tape, running it from the top of the cart, over the dowel and down
the side of the cart. It worked just fine like this for several months.

Interestingly, I haven't had this problem with my new CIS in the same
printer and haven't had to install the dowel since replacing the older CIS.

Tom Keesling
Intelligent Design, Inc.

What Printer?

  ----- Original Message ----- 
  From: jwalpen 
  To: DigitalBlackandWhiteThePrint@yahoogroups.com 
  Sent: Sunday, August 08, 2010 8:39 AM
  Subject: [Digital BW] (unknown)


    
  first set of cartridges still over half full but could not get it to print after 
  multiple cleanings so put in a new set -- same thing -- seem to remember making 
  the catridges go off where they rest and putting a cloth with windex there -- 
  any help would be greatly appreciated as i need to print my artist's business 
  card -- and at 72 i am getting lower on time :-)
  jwpenland

  828 280-9592

  [Non-text portions of this message have been removed]



  

[Non-text portions of this message have been removed]

Which printer?

Mark
http://www.stillrivereditions.com

On May 3, 2011, at 7:26 PM, John wrote:

> I purchased this printer in 2009.

Epson 2880
--- In DigitalBlackandWhiteThePrint@yahoogroups.com, Mark Savoia <mark@...> wrote:

>
> Which printer?
> 
> Mark
> http://www.stillrivereditions.com
> 
> On May 3, 2011, at 7:26 PM, John wrote:
> 
> > I purchased this printer in 2009.
>