Digital BW, The Print

I just sent a message to Roy but I thought I would ask here as well.

I am fed up with Piezography Inks going bad on me and have decided to pursue QTR with 
MIS UT inkset as an alternative.

I installed last night and ordered the UT set from MIS which should show up tomorrow 
(Saturday Delivery because I am in a bind getting a job printed)

The install went very smoothly, but I don't quite understand what to do next.
 I don't see any curves or obvious print settings for printing with this combination in the 
documentation or on the MIS website. I would think that if MIS has custom mixed inks for 
QTR that there would be existing curves for me to print with available at MIS, 
harrington.com, or in the install.

I have a 2200 with MIS UT inks and want to print on Hanemuhle Photo Rag, 
William Turner, and EEM. What do I need to do next? FInd the curves, create my own, (don't 
really understand how.)


James Haney

>
>
> I am fed up with Piezography Inks going bad on me and have decided to 
> pursue QTR with
> MIS UT inkset as an alternative.

Not to discourage you, but the only inkset I ever had go bad on me was 
an MIS quad set, which turned to sludge.  MIS said it was bacteria.  
Well, ok, but I have two other inksets here in two other printers,and 
all three had CISes and they're all three in the exactly the same 
location, stacked on shelves.  The other two are Generations and 
Fotonics.  Generations I've used for years with no problem.  Fotonics 
has been sitting there at least a year.  And I used Piezo inks when 
they first came out, in fact went to MIS after them because the piezos 
were, at that time, at least, so expensive.  But I went through a whole 
set of them first, and the set of MIS didn't last even that long.

James


[Non-text portions of this message have been removed]