Digital BW, The Print

Greeting friends,I'm a newdei in the forum and sorry for this 
introduction, here's my problem..
We just got a new epson 2100 last week run a few test on it, did the 
gray balancer calibration process,did color print testing also, used 
both the matted black ink and photo ink, used both premiun glossy and 
enhance matted, works as expected with just some more fine tuning, in 
short no problem,,,
Had a break over the week end, Mondat, today, did my usual process to 
do some print, but the result is really bad, the color is off, there 
is banding, did the nozzle test, the output pattern is very bad..
I have some jpeg sample i'm attachimg it...
Any idea what's causing these?
Thank in advance, Eric

halfframe35 wrote:

>
>Greeting friends,I'm a newdei in the forum and sorry for this 
>introduction, here's my problem..
>We just got a new epson 2100 last week run a few test on it, did the 
>gray balancer calibration process,did color print testing also, used 
>both the matted black ink and photo ink, used both premiun glossy and 
>enhance matted, works as expected with just some more fine tuning, in 
>short no problem,,,
>Had a break over the week end, Mondat, today, did my usual process to 
>do some print, but the result is really bad, the color is off, there 
>is banding, did the nozzle test, the output pattern is very bad..
>  
>
Obviously if the nozzle test is bad you should perform a couple of 
cleaning cycles ;-) .
-- 

Hans Van Rafelghem
http://www.vanrafelghem.com