Digital BW, The Print

I'm  having trouble installing cis on 1270.  i pump & the ink does 
not go into cartridge.  I want feedback from others who have a 1270 
AND the cis.  boris

boris-

Filling the cart should be no different on the 1270 vs. the 1160, the 
important difference will be which brand of CIS... I am assuming you 
are using the NoMoreCarts in one of its flavors? 

If that is so, the use of the vacuum pump is very clearly outlined in 
the paper instructions the come with the kit. I read them a couple of 
times and followed them exactly and it went smoothly for me. I have 
heard from others who had problems but it seemed that all the issues 
were the same...the "pinching" off of the tubes was too far from the 
end and an incomplete vacuum let air in. Can this be your issue?

If your clamp is not working or is broken, you can use almost any 
clamp type device and bend the tube back to get a perfect seal...the 
tubes are very strong and will not be harmed by this single bending 
(again, I am speaking about the tubes in the nomorecarts type 
cis...others may be different).

Hope this helps,

Tom O'Connell

--- In DigitalBlackandWhiteThePrint@y..., "borismg" <mgkless@h...> 
wrote:

> I'm  having trouble installing cis on 1270.  i pump & the ink does 
> not go into cartridge.  I want feedback from others who have a 1270 
> AND the cis.  boris

Thanks to all those who responded to my post regarding my cis that 
wouldn't load.  The cis is up and running.  The problem was with the 
filter that attaches to the syringe.

Mike Kless