Doepfer

William,

here is a typical patch for wavetable application:

keyboard CV Out -> A-112 CV In
keyboard Gate Out -> A-112 Gate In
ADSR Out -> A-112 Audio In/Wave CV In

A-112 switch positions:

upper switch: S1 or S2
middle switch: Play
lower switch: WAV

If you want control the start position and wavetable range an A-129-3 or
A-138 (new version with offset option) is recommended (ADSR Out -> A-129-3
or A-138 -> A-112 Audio In/Wave CV In).

Greetings to Hawaii
Dieter Doepfer

> -----Ursprüngliche Nachricht-----
> Von: Doepfer_a100@yahoogroups.com
> [mailto:Doepfer_a100@yahoogroups.com]Im Auftrag von William
> Gesendet: Dienstag, 5. September 2006 07:00
> An: Doepfer_a100@yahoogroups.com
> Betreff: [Doepfer_a100] Doepfer A-112 Module (Wave Module) - Questions
>
>
> All, I've been working with the A-112 module...and not getting the
> results I want. I've used the Doepfer Wave dump utility to load
> the 'Wiard wave' File. ..That part went fine. Here is my question...
>
> If anyone has used this module...and felt satisfaction...then how
> did you configure it for playback as well as how did you cable it
> up?
>
> How did I cable up my module?
>
> I used an analog keyboard (Synthesizers.com) and ran the CV out/Gate
> out to the CV IN/Gate in on the A-112 Module. Now...what should I
> use as a control voltage so as to step thru the waves on the wave
> table? On playback I had the S1 switch set to 'Play' and the S2
> Switch to 'Norm', and the S3 Switch to 'Frz'....
>
> Any suggestions here?
>
> Yes, I did read thru the PDF on the A-112 as well. :-)
>
> Mahalo from Hawaii!!