Doepfer

Hi Tim,

Thanks for taking the time to respond.  Your suggestion worked!  I'm very relieved...I'm 
sure you can imagine how annoying it has been to have to re-scale every time i turn it on.
thanks again!

sam 

--- In Doepfer_a100@yahoogroups.com, "Tim Stinchcombe" <timothy@...> wrote:
>
> Hi Sam,
> 
> Check that all the socketted ICs are well seated, especially the 
> small 8-pin DIL at the top edge of the board, marked '24C16' - that 
> is an EEPROM chip and very likely is where such information is stored 
> when the power is off. (The square chip below it, 44 pins, is the 
> processor, and left of that, another DIL, with 28 pins, is the ROM 
> chip holding the software. The only other socketted chip on mine is a 
> MAX531, a digital-to-analog converter, so it is unlikely to be that 
> causing the problem.)
> 
> If that doesn't fix it, then you're going to need some proper help I 
> suspect!
> 
> Tim
> 
> 
> --- In Doepfer_a100@yahoogroups.com, "sam" <sams2cats@> wrote:
> >
> > hello
> > i'm finding that every time i turn on my modular i have to reset 
> the scale on my a190 
> > interface.  i have saved it using the procedure outlined in the 
> manual but still everytime i 
> > need to reset it.  there was a time when it would periodically 
> retain the settings after 
> > powering down but now it never seems to.  any idea what the problem 
> could be?  it's starting 
> > to drive me nuts and i am a patient man.
> > thanks!
> > sam
> >
>