Doepfer

Dear members,

it seems that there were again problems between December 28, 2007 and
January 03, 2008 with the messages I receive from the group. During this
time I did not receive any messages and discovered this today as Anton
reclaimed the missing answer to his message. The problem always appears if I
install an autoresponder for my email account (in this case because of our
Christmas holidays) as Yahoo then stops the forwarding of messages after a
while.

Best wishes
Dieter Doepfer


Here is my response to Anton's lost message:

> Hi Group, Dieter,
>
> I just tested the new modules I got this week and I'm sorry to say that
> twice I got some unexpected behaviour. The 3rd button of the Manual Gate
> does not seem to generate a signal. Button 1 and 2 are ok, no sign of
> any physical damage, the sticker on the back says 'vortest', perhaps
> that's a clue?

As the A-164-1 is a very simple module we asked our manufacturer to test the
module and we did not test it again in our company. Maybe this was a wrong
decision. We'll have an eye to the other A-164-1 we still have in stock and
test them before they leave the company. Please return the A-164-1 for
replacement. I'd like to have the module back so that I can hand it over to
our manufacturer and ask for a statement.

> Also the Precision Adder is default connected to the bus board (it
> immediately influenced the pitch of the a-111's that are in the same
> case) but this is not the behaviour I want, because there's also an
> a-190 in the same case, so I will need to adjust a jumper setting, but I
> think there's not yet any exact information about this on the website.
>
> This last problem seems more serious because of the warning for possible
> short circuit in the a-185-2 text. I have not tried to do any further
> testing as I have an a-190 in the same case. Especially new users could
> maybe get into trouble if this happens to them and they are not aware?
> Or am I getting paranoid now?

Concerning the bus connection: the main problem is that the user's manual is
not yet ready. Of course we will point out that the bus jumper of the
A-185-2 has to be removed if another module is on the same bus board that
applies CV to the bus. In principle the notes of the A-185-1 are valid also
for the A-185-2. I'll add a note to the A-185-2 info page until the A-185-2
manual is ready.