Doepfer

> 
> My first idea: the internal connection is broken. It's a blank wire 
that
> connects the solder point "JP4" of all four boards, located behind 
the mix
> polarizer potentiometer at the pcb edge. But I'd wonder why this 
should
> break if the module is connected to Peter Grenader's model 13 :-)
> 
>


i had a similar problem with my 143-2.  the normalizing gates didn't 
normalize to env # 1.  the blank wire that went through all four 
circuit boards appeared ok, but further scrutiny revealed that it had 
some "wiggle" to it.  it needed to be soldered again, though the wire 
itself was not broken at all, just too loose to have a good 
connection at the joints. 

as soon as i re-melted the solder that was already there it worked 
perfectly.

-t