Doepfer

--- In Doepfer_a100@yahoogroups.com, "thomasborax" <thomasborax@...>
wrote:
>
> 
> > 
> > My first idea: the internal connection is broken. It's a blank wire 
> that
> > connects the solder point "JP4" of all four boards, located behind 
> the mix
> > polarizer potentiometer at the pcb edge. But I'd wonder why this 
> should
> > break if the module is connected to Peter Grenader's model 13 :-)
> > 
> >
> 
> 
> i had a similar problem with my 143-2.  the normalizing gates didn't 
> normalize to env # 1.  the blank wire that went through all four 
> circuit boards appeared ok, but further scrutiny revealed that it had 
> some "wiggle" to it.  it needed to be soldered again, though the wire 
> itself was not broken at all, just too loose to have a good 
> connection at the joints. 
> 
> as soon as i re-melted the solder that was already there it worked 
> perfectly.
> 
> -t
>

Thanks for the advice:)

I check things out tomorrow at work.


Cheers,
thglyph