Doepfer

Hi Dieter,

The four screws in the rear side of the suitcase are inplace, and are
attached to the standoffs inside the case - however, I think the
screws attaching the heat sink to the PCB and into the standoffs have
snapped (If I understand how it should be correctly) 

You can see in this picture, the standoff attached to the rear of the
case is in the square, and the screw coming from it into the case goes
nowhere:

http://www.flickr.com/photos/23732700@N05/3215661296/in/photostream/

I'll try to take a better picture if that would help? 


Many thanks,
TJ




> Florian's comments are 100% correct. The heatsinks have internal female
> threads. So there is no nut required at this position. But the other
side of
> the 4 standoffs (i.e. the female threads of the standoffs) have to be
> mounted with 4 screws at the rear side of the suitcase.
> 
> Just to be sure: can you confirm that the power supply is mounted by
means
> of 2 screws only to the rear side of the suitcase (not 4 as it
should be) ?
> If this applies I ask you to take a picture from the rear side of the
> suitcase that shows the two unused mounting holes.
> 
> Best wishes
> Dieter Doepfer
>