Doepfer

Thanks so much for doing that, Florian!

It's funny, because I followed your instructions and it still didn't work.  I started wondering if it might be because it was the older version of the A-148 (version 2, 1996), so I tried it on my newer A-148, and it worked perfectly.

So, apparently there's some other differences between the two versions of A-148? 

Thanks again, Florian --
Ernst



--- In Doepfer_a100@yahoogroups.com, Florian Anwander <fanwander@...> wrote:
>
> Hello
> 
> >  looking at the left (back) side of the board, these are the two top-right solder points.  Is that correct?
> I think those are not right. I marked the picture from the doepfer website:
> http://fa.utfs.org/diy/a100/doepfer_a-148_marked.jpg
> On the center picture you see the socket on the top. You have to solder 
> the resistor between the lower(!) pins, one direct at the border of the 
> pcb, the other more to the IC.
> On the right picture you can see that the pins are those, which are in 
> Line with the IC. Not the most outer pins!
> 
> Florian
>