Doepfer

Hello,

I installed firmware version v1.2 today and noticed this when using the additional Combi Modes:

When using Mode 1 (which is the 'standard mode' i.e. lower row is gate length) row 1 is dependent to row 2. I mean step 9 always controlling step 1 and so on.

This is different is Mode 2 (lower row is velocity)

Example:

Row 1 = step 1 to 8
Row 2 = step 9

In Mode 2 I can control the entire Row 1 with just the knob of step 9 which is great. (esp. when velocity is controlling Cutoff)

In Mode 1 this is not possible (any more).
In this example step 9 is controlling the gate length of step 1 only.

I don't know if this has been programmed this way deliberately of course but personally I would like that Mode 1 is acting the same way as Mode 2.
Modes 4 (volume) and 6 (pitch) work the same as Mode 2 BTW.


Regards Karel

(BTW Dieter, I send you an email concerning the COTK ratchet sequencer some time ago. I found out that the setup can even be more simple as I thought. I use an A-138a mixer to mix the gates now which works great)