Doepfer

> just me two cents.
> 
> best,
> 
> Peter

... and here are mine:-

Firstly I agree with Peter and various others earlier in the thread - 
keep it simple, so that the new module is complemented by existing 
modules, to allow greatest flexibility without becoming overly 
complicated. For example, if control of direction was a simple 
digital high=backwards/low=forwards (say) input, then adding a A160 
clock-divider into the equation will give required switching for a 
pendulum mode. Use a 163 VC Freq Divider instead gives even more fun 
possibilities - the mind just boggles (and I get the impression that 
list members are *really* taken with the idea of this possible new 
module...)

As for Dieter's info...

> The A-155 control board (this is the small board with
> the 4 buttons and 4 jack
> sockets) has a 10 pin connector that is used to
> control the analog boards
> (potentiometers) and the gate/trigger board
> (switches). The 10 pins of this
> connector have the following functions:
> 
> A0, A1, A2 (adresses for 4051 multiplexer on
> potentiometer and trigger boards)
> Clock

... that the 4051 control pins are so accessible may have sold him 
another module - might just go out and buy one to see what's possible!

Tim

P.S. for Peter:

> prototype of my own at home.  I used an ADC 0804 chip, which 

- are you sure this number is right - had a quick look at Analog Dev. 
site and couldn't find it? Is it just a mere 4 bits, or more like 8 
or 10 and your're just using the top 4?