Doepfer

The output level of the A-111-5 was defined by a resistor (R66, standard
value 47k). If the resistor is replaced you may change the output level
(e.g. 100k for twice the level).

In this regard another question to all members: We receive a lot of
inquiries for the A-111-5 in the vintage version. If anybody knows a
reliable source for CEM3394 (not only one piece but at least a few) please
let me know. If we can find a noteworthy quantity we may manufacture a
limited vintage version of the A-111-5.

Thank you
Dieter Doepfer


> -----Ursprüngliche Nachricht-----
> Von: Doepfer_a100@yahoogroups.com [mailto:Doepfer_a100@yahoogroups.com]
> Gesendet: Freitag, 16. Dezember 2016 07:06
> An: Doepfer_a100@yahoogroups.com
> Betreff: [Doepfer_a100] A-111-5 Volume
>
>
> Hello again,
>
> I have found a second A-111-5 for my Doepfer box (I have enough
> modules than one P-6 case is largely Makenoise, another P-6 is
> largely Doepfer and there are some LC cases as well). Joy! Wish I
> could find these new, but since I can’t, I have to pick them up
> second-hand.
>
> I connected them both up and they sound splendid. No real tuning
> issues I need to care about. The only thing that mystifies me is
> that one unit is a bit louder than the second no matter how I
> plug things.One seems to be a bit below “typical” Eurorack
> levels. Not terribly so, but still significant enough that it
> would require me to constantly work around it by changing the
> output level. Could it be that one VCA knob is out of alignment?
> I am still quite new to the A-111-5. Perhaps there is something I
> am missing? I have an O’Tool Plus that I can use as a voltmeter
> or levels meter. If I am to adjust trimming pot R23 (have not
> tried), is there a set volume or voltage that I should tune both to?
>
> I appreciate this forum so much!
>
> Thanks!
>
> Kazys