Doepfer

You may use this power supply. But the max. output current is then only
500mA. Please refer to the information on our website:

www.doepfer.com > English > PRODUCTS > A-100 > DIY case kit:

"to operate the kit an external transformer with 14-16V/2.4A AC is required,
the current of the transformer has to be twice the value of the +/-12V DC
current, the max. value is 2.4A (corresponding to 1200mA for +/-12V DC),
even smaller current output is possible; the current output of the power
supply is half the current of the external transformer as the currents for
both voltages +/-12V are required (if e.g. the transformer outputs max.
1000mA the max. power supply current is 500mA for +/-12V)"

Best wishes
Dieter Doepfer


> -----Ursprüngliche Nachricht-----
> Von: Doepfer_a100@yahoogroups.com [mailto:Doepfer_a100@yahoogroups.com]
> Gesendet: Freitag, 23. Juni 2017 15:22
> An: Doepfer_a100@yahoogroups.com
> Betreff: [Doepfer_a100] Re: A-100 LC3 PSU (?)
>
>
>
>
>
> Sorry I was wrong in the description of the problem, forget it.
>
>
> My worry here concerns the fact that a (not original) 1000mA
> transformer is used for a (supposed) 1200mA power supply. I say
> “supposed” because I don’t know whether this case came with a
> lower supply mA value than today’s model (the original Doepfer
> transformer installed today delivers 2400mA).
>
>
> So, the PSU and the board are original Doepfer, the external
> transformer is not.
>
>
> Do you think this might cause issues to the power supply, the
> board or the modules?
>
>
> The link describes the not original transformer..
>
>
> http://www.velleman.eu/products/view/?country=fr&lang=en&id=365838
>
>
> Since I already own this case with 1200mA and the original ext.
> transformer (2400mA), would be technically possible to use this
> original transformer for both cases at the same time?
>
>
> Best,
> dxx
>
>
>
>
>
>
> Il giorno 18 giu 2017, alle ore 22:47, Diego Ragnini
> <diegora@free.fr> ha scritto:
>
>
> Hi everybody
>
>
> A guy sells a second hand 2,5 years old A-100 LC3 of 1000mA, with
> a PSU which is not the original one. Apparently it had few issues
> and decided to replace it for not clearly specified reasons. He
> forwarded me the link for this PSU
>
>
>  http://www.velleman.eu/products/view/?country=fr&lang=en&id=365838
>
>
> I would be glad if someone could confirm the compatibility with
> the Doepfer system. He states that everything works flawlessly
> with it. I am surprised to know about issues on the original
> transformer for this unit, which I own in the new version
> (1200mA) and cannot find anything to complain about its PSU,
> absolutely sturdy and reliable.
>
>
> Best regards,
> Diego
>
>
>
>
>