Doepfer

Thanks Bakis for this info
Sadly, the doepfer cable sockets do not fit into the AS module 
sockets (too wide), so I will need to order an AS cable first

I will post again once I get it working

regards
Joost

--- In Doepfer_a100@yahoogroups.com, Bakis Sirros 
<synth_freak_2000@y...> wrote:
> hi joost,
> yes,the doepfer and a.sol. ribbon cables are the same,
> AFAIK.the red stripe goes to the word"stripe" or to
> -12volts.so,in most of the A.SOL. modules the ribbon
> connector goes with the red stripe up.if you look at
> the doepfer buss board and the SY02 pcb ,you will know
> how to connect the ribbon cable.the ribbon cable goes
> with the red stripe at the bottom in the doepfer
> board!(stripe to -12volts.)
> bakis.
> 
> 
> 
> --- levka0 <levka@w...> wrote:
> > Hi There
> > I just got a used AS SY02 filter (could not wait for
> > Doepfer's own MS-
> > 20 reincarnation ;)), and I am wondering how to
> > connect it.
> > The AS site gives some advise; it appears that on
> > the AS modules the 
> > -12 V pin is located at the top side of the
> > connector (in contrast 
> > with doepfer's own modules); so it seems to me that
> > AS should 
> > connect "upside-down" compared to Doepfer.
> > 
> > Anybody here with a clue ?
> > 
> > regards
> > Joost
> > 
> > 
> 
> 
> =====
> Bakis Sirros
> Parallel Worlds / Polariton
> Athens-Greece
> [Doepfer_a100] group owner
> http://www.rubber.gr
> http://www.ward12.com
> 
> __________________________________
> Do you Yahoo!?
> Yahoo! SiteBuilder - Free, easy-to-use web site design software
> http://sitebuilder.yahoo.com