Doepfer

I think I read your post a bit too quickly and misinterpreted your 
problem...  haven't had this problem myself.
Sorry. 
Goodluck anyway.
/gustaf

--- In Doepfer_a100@yahoogroups.com, "gargar1974" <gustaf@p...> wrote:
> 
> 
> The trig outs output what you have in the clock in.
> What are you using in the input?
> So if you drive it with a square lfo, it will output a rising edge 
> and then a falling edge. Maybe what you are trigggering reacts to 
> both? I use it with the square wave from A-145 and send the trigger 
> out to the A-140 and I dont have this problem.
> 
> I think you'll like this module. I love it.
> 
> /gustaf
> 
> 
> --- In Doepfer_a100@yahoogroups.com, "Paul Wagorn" <pwagorn@p...> 
> wrote:
> > Ok, so I've only had this module for a short while, but I'm 
having 
> a strange
> > issue that is more likely me not understanding something than a 
> problem with
> > the module:
> > 
> > On the cv out for each row, at each step it actually pulses twice 
> for each
> > "note" in the sequence.  I don't have a scope to verify exactly 
> what it's
> > doing, but if I pluf the pre or post out into an oscillator, it 
> plays each
> > step twice (and I'm not using a vca!), I assume it's outputting 
> some sort of
> > square wave for some reason.  Even when I advance the step 
> manually, for
> > each step it goes "beep - beep"  (again without any vca)
> > 
> > Am I missing something basic here?  I think I understand the 
theory 
> of the
> > 155, and I've had lots of other analogue sequencers, and I've 
never 
> seen
> > this.
> > 
> > Paul