Doepfer

Hello, I would like to ask a question about the forthcoming A135-2!

Are the CV inputs going to be normalled just as the signal inputs?

I ask this because in A135-1 both CV and signal inputs are normalled.

Hello,

in the A-135-2 only the audio inputs can be normalled via jumpers. Because
of the very compact design there was no space left on the pc board for the
CV normalling jumpers. We discussed if we add the CV normalling features
without jumpers (i.e. permanent normalling). But in the past we had problems
with fixed normalling because some customers complained that the module is
faulty as they were not aware of the normalling or did not understand this
feature.
But it's very easy to add the CV normalling by means of 3 short wires that
connect the corresponding terminals of the sockets. In the technical
document of the A-135-2 we will explain that.

Best wishes
Dieter Doepfer

> -----Ursprüngliche Nachricht-----
> Von: Doepfer_a100@yahoogroups.com [mailto:Doepfer_a100@yahoogroups.com]
> Gesendet: Mittwoch, 14. November 2018 20:11
> An: Doepfer_a100@yahoogroups.com
> Betreff: [Doepfer_a100] A135-2 Quad VCA / Voltage Controller Mixer
>
> Hello, I would like to ask a question about the forthcoming A135-2!
> Are the CV inputs going to be normalled just as the signal inputs?
> I ask this because in A135-1 both CV and signal inputs are normalled.
>
> Posted by: exakoustidismiltiadis@hotmail.com

I hope that the first batch will be sent to our international distributor
(Alex4 in Berlin) early in December. It depends upon the pre-orders of the
shop in question when the module will be available in the shop.

Best wishes
Dieter Doepfer

> -----Ursprüngliche Nachricht-----
> Von: Doepfer_a100@yahoogroups.com [mailto:Doepfer_a100@yahoogroups.com]
> Gesendet: Donnerstag, 15. November 2018 16:56
> An: Doepfer_a100@yahoogroups.com
> Betreff: [Doepfer_a100] Re: A135-2 Quad VCA / Voltage Controller Mixer
>
>
>
>
> Thank you Dieter for your invaluable information! Do you know
> when this module
> will be at shops?
>
>
> Best regards
> Miltos