Doepfer

>i think this has been discussed before, but it's been a while..   what i 
>di=
>d to eliminate hum on my a199 was use a much longer phono cable for
>connecting the reverb tank to the module and place the module as far away
>from any power supplies as possible.  mine's about a meter away on a 
>shelf.=
>you'll need to drill a hole in the bottom of the case in order to pass the 
>=
>cable through (and if you pass the cable through BEFORE solderig the phono 
>plug
>onto the end you can use a much smaller hole).  got rid of all hum for 
>me..=

I did the same except I just removed the back panel, ran the cable out and 
refitted the panel.  No holes.  No fuss.  I found that I didn't even need to 
extend the cable, I just experimented with orientation of the spring unit 
until the hum disappeared.

Pierre

_________________________________________________________________
Unsatisfied with being single?  Try MSN Personals 
http://www.msn.co.za/personals/