----- Original Message -----From: fddiSent: Saturday, March 31, 2012 2:09 PMSubject: Re: [Ensoniq-VFX-SD] poly at not working properly in sd1Could someone tell me in particular which ROM patch does aftertouch while fully pressing one key ?
I tried to trigger aftertouch but it looks like it's not working...
than kyou
Rick
On 3/28/12 2:16 PM, fddi wrote:
Sorry my ignorance how can I check if poly works on my SD-1 ?
I just bought one right now at 21 voices
Rick
On 3/28/12 1:57 PM, jammie wrote:after doing some extensive tests
the problem with the sd1 is the kpc emulator board revision 2.23 software
i had a eps i brought broken for repair and removed the kpc emulator revision 1.50 and fitted it to the sd1 keyboard and the poly at was working as it should
so i put the kpc 2.23 on the eps after i serviced it needed the psu updated to newr caps and 1 power reg and a new replacement floppy
and did the tests of the 2.23 version kpc emulator board
and it would not respond with out breaking fingers
so the problem is not the the keys or there rubber stops as i tested the rubber stops and they are designed in a way that the 2 triangle prongs flaten when pressed hard
as i dedueced that the keyboard works fine with the kpc board v150
i dont know what ensoniq did but the firmware must be beta and was never fixed its as tho they turned the sencitivity down to low
whether we can downgrade the firmware is another story i will have to coppy the 150 firmware to see if it can be exchanged to the kpc 2.23 board
as they both use the same scanner chip and its identical board
Message
Re: [Ensoniq-VFX-SD] poly at not working properly in sd1
2012-03-31 by jammie
most respond to it from the rom
section
most just do vibrato some do pitch change some do
filter sweeps
you know if its working when you press it the
effect gets stronger
like if you were turning the mod wheel fully open
at hardest press