Patches and discussion for Ensoniq VFX family

my sequencer saves fine never have to reload it unless i do a software reset or hardware reset when changing battery

the eps has to load in its os system to work other wise its a dead brick

but the vfx-sd/sd2/sd-1/sd-1/32 and the sq1/2 ks32/ts10/12/mr/zr

all have there os on eprom and only need to do re installs when reset 
  ----- Original Message ----- 
  From: Eric Hall 
  To: Ensoniq-VFX-SD@yahoogroups.com 
  Sent: Sunday, June 17, 2012 4:56 PM
  Subject: Re: [Ensoniq-VFX-SD] SD-1/32 forgets sequencer &c, though battery seems OK


    

  My VFX-SD saves the sequencer fine. The only time I have to reload it is after a crash - and that happens very seldom.


  Eric 




------------------------------------------------------------------------------


    

  Sorry if I have mis-read this thread.
  The sequencer OS IS NOT SAVED at power down ! This code must be reloaded via floppy each time you want to use the sequencer. Why this was done, I do not know. but it is the same on the EPS, VFX and SD-1.

  Bill