Homebrew PCBs

Hi Bob,

I have the 4" version of the GBC. I have run .062
boards through it. The trick is to feed them in at a
slight angle, so the rollers only grab a corner at
first. Trying to feed these boards in square causes
the GBC to choke.

TANSTAAFL!

Myc

--- bob_ledoux <bobledoux@...> wrote:

> --- In Homebrew_PCBs@yahoogroups.com, "Keith
> Applegarth"
> <keith.applegarth@...> wrote:
> >
> > Just going to throw in my 2 cents... I picked up a
> GBC 9in laminator 
> > from Office Max for $30. Four passes and the toner
> is fused to the 
> > copper. 
> > 
>  Have you used it for anything thicker than .032
> board?  Pulsar sells
> this unit as part of their Toner Transfer System
> starter's package. 
> But they say it is limited to thin board.
> 
> I'd like to try mine on some small--2 x 3 inch .062
> boards.  Perhaps I
> could just run the boards in the middle of the
> opening.
> 
> 
> 
> 


__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com